WECL Distribution FLUKE Hong Kong & Macau Distributor Fluke Fluke Networks Hong Kong &  Macau Distributor
 
  Home > Products > Vibration Testers >
 
 
Products
> Thermal Imagers
  ● Expert Series
      > TiX1000
      > TiX660
      > TiX640
      > TiX560
      > TiX520
  ● Professional Series
      > Ti400
      > Ti300
      > Ti200
  ● Performance Series
      > Ti32
      > Ti29
      > Ti27
      > Ti125
      > Ti110
      > Ti105
      > Ti100
      > Ti95
      > Ti90
> Fluke Connect™
> Visual IR Thermometers
      > VT04
      > VT04A
      > VT02
> Power Quality Tools
      > 435II
> Vibration Testers
      > 805
      > 810
> Cable Network Testers
      > Cable Verfication
      > Cable Qualification
      > Cable Certification
> IAQ
      > 971
      > 975
      > 975V
> Battery Analyzers
      > BT508
      > BT510
      > BT520
      > BT521
> Others
      > Digital Multimeters
      > Clamp Meters
      > 975
      > 975V
 
 
805 Vibration Meter Contact us for more details
 
FLUKE 805
FLUKE 805
FLUKE 805
FLUKE 805
temp-thumb
temp-thumb
temp-thumb
temp-thumb
Features

Superior image quality
Innovative sensor design helps minimize measurement variations caused by device angle or contact pressure
• Consistent data quality at both low and high frequency ranges
• Four-level scale indicates severity of problems for overall vibration and bearing condition
• Exportable data via USB
• Trending in Microsoft® Excel using built-in templates
• Overall vibration measurement (10 Hz to 1,000 Hz) for acceleration, velocity and displacement units of measurement for a wide variety of machines
• Crest Factor+ provides reliable bearing assessment using direct sensor tip measurements between 4,000 Hz and 20,000 Hz
• Colored lighting system (green, red) and on-screen comments indicate how much pressure needs to be applied to take measurements
• Temperature measurement with Infrared Temperature Sensor increases diagnostic capabilities
• On-board memory holds up to 3,500 measurements
• Audio output for listening to bearing tones directly
• External accelerometer support for hard to reach locations
• Flashlight for viewing measurement locations in dark areas
• Large screen with high resolution for easy navigation and viewin


Specifications

Vibration Meter
Low frequency range (overall measurement) 10 Hz to 1,000 Hz
High frequency range (CF+ measurement) 4,000 Hz to 20,000 Hz
Severity levels Good, Satisfactory, Unsatisfactory, Unacceptable
Vibration limit 50 g peak (100 g peak-peak)
A/D converter 16-bit
Signal to noise ratio 80 dB
Sampling rate
    Low frequency
    High frequency

20,000 Hz
80,000 Hz
Real time clock backup Coin battery
Sensor
Sensitivity 100 mV g ± 10%
Measurement range 0.01 g to 50 g
Low frequency range (overall measurement) 10 Hz to 1,000 Hz
High frequency range 4,000 Hz to 20,000 Hz
Resolution 0.01 g
Accuracy At 100 Hz ± 5% of measured value
Amplitude Units
Acceleration g, m/sec2
Velocity in/sec, mm/sec
Displacement mils, mm
Infrared Thermometer (Temperature Measurement)
Range -20 °C to 200 °C (-4 °F to 392 °F)
Accuracy ±2 °C (4 °F)
Focal length Fixed, at ~3.8 cm (1.5")
External Sensor
Note: Fluke supports but does not provide external sensors
Frequency range 10 Hz to 1,000 Hz
Bias voltage (to supply power) 20 V dc to 22 V dc
Bias current (to supply power) Maximum 5 mA
Firmware
External interfaces USB 2.0 (full speed) communication
Data capacity Database on internal flash memory
Upgrade Through USB
Memory Up to 3,500 measurements
Radiated Emission
Electrostatic discharge: burst Standard EN 61000-4-2
Electromagnetic interference Standard EN 61000-4-3
RE Standard CISPR 11, Class A
Environmental
Operating temperature -20 °C to 50 °C (-4 °F to 122 °F)
Storage temperature -30 °C to 80 °C (-22 °F to 176 °F)
Operating humidity 10% to 95% RH
(non-condensing)
Operating/storage altitude Sea level to 3,048 meters (10,000 feet)
IP rating IP54
Vibration limit 500g peak
Drop test

1 meter

General Specifications
Battery type AA (2)Lithium Iron Disulfide
Battery life 250 measurements
Size (L x W x H) 24.1 cm x 7.1 cm x 5.8 cm
(9.5 in x 2.8 in x 2.3 in)
Weight 0.40 kg (0.89 lb)
Connectors USB mini-B 7-pin, stereo audio output jack (3.5 mm Audio Plug), external sensor jack (SMB connector)

 
   
 
 
 
 
 
FLUKE 975 AIRMETER
Vibration Tester & Meter Fluke
Click to try the CNX system online
Download FLUKE 2015 Catalogue   Register for FLUKE Ti Thermal Imager Demo
 
     
     
Hotline:(852) 3182 0888    |     Fax:(852) 3182 0808     |     Email:cs@wecl.com.hk
 
Solutions
● Electrical
● Building Diagnostics
● Energy Management
● Mechanical
● Network Management
 
Products
● Fluke Connect™
● Thermal Imagers
● Visual IR Thermometers
● Power Quality Tools
● Vibration Testers
● Cable Network Testers
● IAQ
 
Support
● Demonstration
● Application Notes
● Tools
● Videos
 
About Us
 
Contact Us
 
Home